PingWise can watch a Linux server itself, not only what it serves. A short shell script on the server reads the system's own figures every two minutes and sends them to us. We hold no password or key of the server, and the script opens no port.
Connecting
Integrations → Connect a Linux server. The next page shows a few commands with a key, once. Paste them as root on the server. They:
- save the key in a file only root can read;
- save the script as
/usr/local/sbin/pingwise-sync; - add a cron entry that runs it every 2 minutes;
- run it once, so the first report arrives at once.
Back on the connection's page you see the server and what would be added, and nothing is created until you press Add and keep watching.
For another server, paste the same commands there. One connection takes any number of servers; each reports under its own host name.
It needs cron and curl, which almost every Linux has. Drive health needs smartmontools on the server; without it the drives are listed with no health.
What the script sends
You can read the whole script on the install page before you paste it. To see exactly what it would send, without sending anything:
/usr/local/sbin/pingwise-sync --print
It sends:
- the server's host name and IP addresses, public and private (only a public one gets a ping monitor);
- its system and kernel version, and its uptime;
- CPU and memory use;
- how full each filesystem is;
- each drive's model, SMART health and, for NVMe drives, wear;
- the state of ZFS pools and software RAID.
It never sends files, processes, users, logs, configuration or passwords, and it changes nothing on the server.
What you get
- A ping monitor on the server's public address. A server with only private addresses gets none; its status and limits are still watched.
- A status monitor, up while reports keep arriving and down after 6 minutes of silence.
- Warnings when a limit is crossed: CPU or memory high for 10 minutes, a filesystem above 90% full, a failing or worn drive, a degraded ZFS pool or RAID. Warnings never count as downtime. See Servers for the limits.
- A page under Servers with the charts and the drives.
Removing it
On the server, as root:
rm /etc/cron.d/pingwise-sync /usr/local/sbin/pingwise-sync /etc/pingwise-sync.conf
Then press Remove this server on its page under Servers. To stop all servers of a connection at once, disconnect the connection; its monitors stay as ordinary monitors.
Last change: 11 November 2026.